Sponsored Links
 

Get Latest Jobs Via Email

Part 2 : We begin to draw (Lesson:6 Line Autocad)

Part 2 : We begin to draw (Lesson:6 Line Autocad)autocad

Sponsored Links

The command “LINE”.

Well at this point it’s time to start drawing.
On the “draw” toolbar click the left mouse button on the command ‘line’
is the key with this icon  line = LINE
Now look what came written in the “command line”.

command line
The program suggesting steps that have to do to create a line, in this case is asking you to “Specify first point” (to specify the first point of the line).
Now click with the mouse in a point mean any of the canvas and then looks back at what appears in the “command line”:
“Specify next point” (specify the second point).
Now move the mouse on one side and you’ll see that you are creating a line, before clicking the second test with the mouse to rotate around the first point you’ve already laid down, you’ll see the line that follows your movement in all directions .
Click and then at another point in the drawing slightly away from the first, doing so will create the first line between the two points just defined.

At this point, the program gives you the opportunity to continue to create more connected line segments to the first, by clicking with the mouse in other areas of the screen.
To stop the command and end the line, click the right mouse button, or press the “enter” key on your keyboard.
You can resume the command line just completed by pressing one of two buttons (right-click or enter), or by clicking again the “line” button line on the toolbar.

To create a line and then it took at least four clicks of the mouse:
beginning of the command, the first point, second point, the end of the control (Right).
To run the various commands of AutoCAD you must use different combinations of mouse buttons that we will see from time to time, with practice you will become automatic and runs them without thinking.

However, if during the execution of this or any other commands you seem to have some wrong step by clicking the “esc” key on your keyboard to quit the command and you can start over.

The latest versions of AutoCAD may be that during the execution of commands, some information and numbers will be displayed next to the cross-hairs, and repeat the “command line” informations, and others. It’s called “dynamic input and can be turned off by clicking on the” DYN “bottom of the screen, under the command line.
Personally I find it annoying but it is subjective, however, should turn it off initially.

Share This Job !
Share On Facebook
Share On Twitter
Share On Google Plus
Share On Linkedin
Share On Pinterest
Share On Reddit
Share On Stumbleupon
Contact us


Get Latest Jobs Via Email

Submit Your Cv
submitCv

Close